superconsultant.blogg.se - Raid 0 for mac osx sierra

Raid 0 for mac osx sierra mac os x#
Raid 0 for mac osx sierra mac os#

In this guide, you'll be writing several boot files, located inside the Chimera installer, onto the boot partitions of the hard disks in your RAID 0 array.

Raid 0 for mac osx sierra mac os#

Standalone installer for Chimera bootloader: Chimera is the bootloader that most Hackintoshes use to start Mac OS X.

Be sure to connect these 2 hard disks to your computer's motherboard before beginning the process described in this guide. The disks don't necessarily have to be identical, but you'll get better and more reliable performance from identical ones.

Raid 0 for mac osx sierra mac os x#

Mac OS X cannot boot off a partition larger than 1 TB, so these hard disks cannot be larger than 1 TB. These hard disks will make up the RAID system itself. Instead, you must own two (or more) extra hard disks, in addition to the hard disk currently being used by your working Hackintosh. 2 extra hard disks: Unfortunately, because of the way RAID must be set up in Mac OS X Lion, Mountain Lion, and Mavericks, you cannot install Mac OS X directly onto a RAID 0 array.Check out our installation guides section for more information.

A working Hackintosh running Lion, Mountain Lion, or Mavericks: For the purposes of this guide, you need an already-working Hackintosh.

Be sure to consider these risks before reading on. So while a RAID 0 array doubles performance, it also doubles the failure rate. NOTE 3: RAID 0 arrays do not offer any file redundancy if a single hard disk in your array fails, the entire array fails. NOTE 2: This guide is unnecessary if you install OS X Mountain Lion with iAtkos ML2. Unlike with Unibeast or similar tools, the iAtkos version of the Mountain Lion installer supports software RAID 0 arrays by default. Simply create an array by using the Disk Utility app inside the iAtkos installer (see Step 1 of this guide), and then install Mountain Lion straight onto there. NOTE 1: Though this guide refers to Chimera bootloader, it will also work for Chameleon bootloader, which is essentially the same thing. Fortunately, the process itself isn't too difficult.

Since these boot partitions are system-protected by default, you can only modify them through Terminal. To be able to boot your computer from the RAID 0 array, you must install Hackintosh boot files onto all of these boot partitions. When Mac OS X sets up a RAID 0 array, it creates a small "boot partition" for each of the hard disks inside the array. The last part of the process is the most important.

Then, clone the contents of your current Mac OS X installation onto that RAID 0 array. First, you need to create a software RAID 0 array in Disk Utility. The process for setting up a RAID 0 system on Lion, Mountain Lion, or Mavericks can be divided into three main parts.